Parts for 10687884100 — Whirlpool dryer Repair

Looking for parts that fit your Whirlpool 10687884100 dryer? This model has 80 parts documented in our catalog -- below are the 45 most model-specific matches, plus what failure each one points to and how to make sure you are ordering for the right unit.

Compatible Parts for 10687884100

This model has 80 parts documented in our catalog. The 45 below are the most model-specific matches -- the ones shared with the fewest other models -- sorted from most specific to broadest fit. Where we have a page with full specs for a part, its number links there; otherwise, search that exact part number directly.

Reference Price is an informational market range seen for that part across the catalog -- not an offer, and not a price charged by RepairKitHub. RepairKitHub does not sell parts; it links out to Amazon.

Most Common Failures on This Model

The parts above group into a handful of failure areas. Here is what each points to and how to check it before you order anything.

General hardware and mounting parts

Symptom: A small mechanical or mounting part has failed, cracked, or gone missing.

Check: Compare the physical shape and mounting points to the original piece, and confirm the exact part number against your model plate before ordering.

Parts in this group on the 10687884100: 279311 (Igniter Kit), 279834 (M Series New Style Coil Kit), 279923 (Gas Valve Kit), W10295523 (PLUG), W10545924 (DRUM), W11129408 (HOUSNG-OUT), W11222083 (Power Cord), W11236646 (WASHER), W11299300 (BULKHEAD), WP229742 (Orifice Burner), WP234826 (Dryer Natural Gas Orifice), WP357213 (Nut-Push-In), WP358160 (Washer Nut), WP660658 (Dryer Clampmotor), WP694424 (Natural Gas Limiter).

Drive system (belts, pulleys, motors)

Symptom: A drum or tub that won't turn, a burning-rubber smell, or a loud thump or squeal during a cycle.

Check: With power off, turn the drum or tub by hand -- resistance or grinding points to the motor or a bearing, and a cracked, glazed, or snapped belt is visible once the cabinet is open.

Parts in this group on the 10687884100: 279787 (Drive Motor with Threaded Shaft - 120V 60Hz), W10837625 (Motor Pulley), WP3389420 (Idler Retainer), WP3393657 (Restrainer, Belt).

Door and drum seals

Symptom: A drum seal that's worn through, letting the dryer pull in room air instead of pushing heated air through the load.

Check: Look for the drum seal fraying or missing where it meets the front or rear bulkhead -- worn felt or foam here is visible once the front panel is off.

Parts in this group on the 10687884100: 280114 (Dryer Drum Seal with Adhesive).

Storage, trim and cosmetic hardware

Symptom: A cracked shelf, broken door bin, worn hinge, or missing trim piece -- cosmetic and storage wear rather than a functional breakdown.

Check: Match the physical dimensions and mounting tabs of the old part before ordering; these pieces are often model-specific even between visually similar models.

Parts in this group on the 10687884100: 3389888 (BRACKET), 8212450A (RACK-DRY), WP297092 (Dryer Single Access Panel Clip), WP3351614 (Washer Screw Ground), WP3387230 (Screw - 10-16 x 1), WP3387242 (Seal Panel), WP3387559 (Dryer Door Hinge Left Side), WP3387565 (Door Spring), WP3388229 (Dryer Retainer Spring Clip), WP3390631 (Washer Screw 818 X 1/2), WP348721 (Dryer Door Handle), WP388257 (Trim Ring), WP388326 (Console Screw), WP688805 (Washer Knob Springclip), WP694298 (Bracket, Ignitor), WP694422 (Spring Regulator), WP697813 (Dryer Seal Outlet Housing).

Venting and airflow

Symptom: A dryer that needs multiple cycles to dry, runs unusually hot, or repeatedly trips its heat-limit switch.

Check: Clear the lint screen and the full vent run to the outside wall -- a restricted vent is the single most common cause of long dry times and repeat thermal-fuse failures.

Parts in this group on the 10687884100: W10470674 (Side and Bottom Vent Kit), WP3387223 (Moisture Sensor), WP3406797 (Dryer Toe Panel), WP697772 (Blower Wheel).

Heat control (thermostats, fuses, heating element)

Symptom: The dryer runs but produces no heat, or it shuts off partway through the cycle.

Check: With the dryer unplugged, check continuity across the part with a multimeter -- no continuity means it has failed. Clear the lint vent first, since a blocked vent is what usually trips a thermal fuse in the first place.

Parts in this group on the 10687884100: WP3390719 (Dryer Disposable Thermal Fuse), WP694674 (Cycling Thermostat - Limit 135/155).

Door, lid switches and latches

Symptom: The dryer won't run, or stops, unless the door is fully latched shut.

Check: Listen for an audible click when the door closes. No click, or a visibly cracked plastic tab on the latch, points to this part.

Parts in this group on the 10687884100: WP3391902 (Dryer Door Switch).

Controls, timers and wiring

Symptom: A cycle that doesn't advance, an unresponsive display, or the dryer not starting at all.

Check: Look for burn marks or a burnt smell near the board or terminals, and check whether buttons and knobs respond -- a unit that powers on but won't cycle often traces back to this group.

Parts in this group on the 10687884100: WP3401850 (Wiring Harness).

How to Confirm This Is Your Model

On Whirlpool dryers, the model and serial plate is usually just inside the door frame, or on a label on the back panel or top of the cabinet.

Whirlpool model numbers are not random strings: they typically open with a letter prefix that identifies the appliance platform or series, followed by a run of digits that encode capacity, features, or generation, and close with a letter-and-digit combination that usually maps to color and a production revision. That closing piece matters more than it looks -- two model numbers that differ only in the last character (for example ending in 0 versus 1) can belong to different production runs with different part revisions, even though the rest of the number, and the appliance's outward appearance, are identical. That is why part fitment has to be checked against the complete model number, not an abbreviated version of it.

Before ordering anything for the 10687884100, match the complete string on your plate -- letters, digits and all -- against 10687884100, rather than relying on memory or a partial number.

What to Have Ready

Before you order, it helps to have the following on hand -- especially the last character or two of the model number, since a production revision only a letter or digit apart can carry a different part list even when the rest of the number, and the appliance itself, look identical.

• The full model number from the plate, copied exactly, including any letters before or after the digits.
• The serial number from the same plate, which some lookup tools ask for to narrow down a production run.
• A description, or a photo, of the part you believe has failed -- including any numbers printed or stamped on it.
• The brand name printed on the plate itself -- appliances are frequently rebadged across brands on shared platforms, so the plate's brand can differ from the name on the outside of the cabinet.

Before You Buy

Once you have matched a part number above to your repair, check that exact string against what is stamped on your dryer's plate and, if it is still legible, printed on the part you are replacing. RepairKitHub does not sell parts directly -- each part number above is a starting point for a search on Amazon, where you can compare listings against the number you have confirmed.

More Resources

• Look up your model number -- search the full catalog directly by model or part number.
• Start from a symptom -- browse repair guides organized by what the appliance is doing wrong.
• Other Whirlpool dryer models: 10687884300, 10687884600, 11060012000, 11060012001