How to Install Dishwasher Silverware Basket 5005DD1001B in an LG Dishwasher

Quick answer: Pull the lower rack out, lift the old basket off its hooks, and hang 5005DD1001B in the same spot: the hooks on the basket's back drop over the rack wires at the front or side. Push down until it sits flat, close the lids, and confirm the lower spray arm clears the basket when you spin it.

The silverware basket on an LG dishwasher is a removable plastic bin with hinged lids and hook tabs on the back that hang on the lower rack wires. Part 5005DD1001B is the replacement basket for LG models such as the LDF7561ST, LDF7551ST and LDT9965BD00 as well as the Kenmore 72214693610 that LG builds. Baskets fail in predictable ways: the lid hinges snap, the hook tabs crack after years of being lifted while full, or the floor grid breaks and lets forks drop through onto the spray arm.

There are no tools involved and no need to touch water or power, but a basket that is hung in the wrong position or not fully seated will block the lower spray arm or the detergent dispenser door, and that shows up as dirty dishes and a detergent block still stuck in the cup. This guide covers where the basket goes on these LG racks, how to seat it so it stays put, and how to load it so the new one lasts.

See part details and every compatible model: 5005DD1001B

⚠️ Safety First
  • Let the dishwasher cool if it just ran; the rack and basket hold heat.
  • Empty the old basket before lifting it out so knives are not loose in the tub.
  • Check the rack for broken wire tips that could cut you where the basket hangs.

Tools and Parts You Need

  • Nothing beyond your hands for the swap itself
  • Old toothbrush for cleaning the rack wires where the basket hangs
  • White vinegar or dish soap for scale on the rack
  • Flashlight to check the spray arm clearance
  • Towel to set the old basket on

Step-by-Step Installation

  1. Empty and pull the lower rack Open the door, take out any dishes, and slide the lower rack all the way forward so the basket is in front of you.
  2. Remove the old basket Grip the basket by its sides and lift straight up. The hook tabs on the back release from the rack wires. If a broken tab is wedged, wiggle the basket toward the rack center and lift again.
  3. Clean the mounting wires Scrub the rack wires where the basket hangs with a toothbrush and vinegar to remove scale and food film. Rinse and dry. Inspect the wire coating for splits.
  4. Identify the hanging position On these LG racks the basket hangs across the front, and on some models it can move to the side to make room for large items. Match the position of the old basket unless you are deliberately relocating it.
  5. Hang 5005DD1001B Hold the new basket with its hook tabs facing the rack, tilt the top toward the rack, and drop the tabs over the wires. Press down until the basket is level and sits flat on the rack floor.
  6. Check the lids and dividers Open and close each lid. They should snap shut and hold. If your household prefers open loading, fold the lids back fully so they do not rub the rack above.
  7. Confirm spray arm clearance With the rack pushed in, reach under and spin the lower spray arm by hand. It must turn a full circle without touching the basket.
  8. Test with a load Load a normal mix of utensils, run a cycle, and check that the detergent dispenser opened and the utensils came out clean.

Fit Checks Before You Call the Job Done

  • The basket sits level and does not rock when pushed at the top corners.
  • All hook tabs are over the rack wires, not resting on top of them.
  • The lower spray arm spins freely with the rack in place.
  • The detergent dispenser door on the inner door panel is not blocked by the basket.
  • The rack rolls in and out without the basket catching on the door gasket.

Common Mistakes to Avoid

Hanging it on the wrong wires One row too high leaves the basket tilted and the tabs strained. Line the tabs up so the basket floor rests on the rack.

Lifting a full basket by one lid This is how hinges break. Lift by the basket body with both hands.

Overloading one compartment Packed utensils nest together and stay dirty, and the extra weight cracks the floor grid.

Placing it in front of the dispenser If the basket blocks the detergent cup, the tablet stays stuck and nothing gets clean.

Putting long knives point-up near the rack edge Points can reach the tub wall or the door and scratch the gasket. Load sharp items point-down.

Troubleshooting After Installation

Utensils still dirty after a cycle Spread them out, mix spoons with forks so they do not nest, and confirm the lower spray arm is not hitting the basket.

Basket falls off when the rack is pulled out The tabs are resting on top of the wires instead of hooked over them. Reseat it and press down firmly.

Small items fall through to the sump Use the lid compartments for small items or a mesh utensil holder; check the tub filter for anything already dropped.

Rack does not slide in fully The basket is hung on the side and is hitting the tub wall. Move it to the front position.

Care Tips After the Repair

  • Rinse the basket under the tap monthly and clean the lid hinges with a brush.
  • Do not put the basket in an oven or dishwasher sanitize cycle with the lids open and unloaded; the hinges can warp.
  • Alternate utensils handle-up and handle-down so water reaches every surface.
  • Replace a basket with a cracked floor before a dropped knife damages the spray arm.

Compatible Models (Sample)

This part is listed for 68 LG models in our fitment data. Always confirm your exact model number on the appliance's rating plate.

Repair Difficulty and Time

Difficulty: Easy. Typical time: 5 to 10 minutes.

Frequently Asked Questions

Does 5005DD1001B fit Kenmore Elite dishwashers?

Yes. LG builds Kenmore Elite units like the 72214693610, and the basket is listed for it along with LG models such as the LDF7810BB01 and LDF8764ST.

Can I hang the basket on the door instead?

No. These LG models use a rack-mounted basket. The hook tabs are designed for the lower rack wires only.

Do I need to remove the lower rack to install it?

No. Pulling the rack forward gives full access. Removing it is only needed if you want to clean the whole rack.

Why did my old basket break?

Most fail from lifting a loaded basket by the lids or from years of heat cycles making the plastic brittle. Lift by the body and keep loads moderate.

Final Checklist

  • Dishwasher cooled and lower rack emptied
  • Old basket lifted off and rack wires cleaned
  • Hanging position matched to the old basket
  • 5005DD1001B hooked over the wires and pressed flat
  • Lids checked and dividers positioned
  • Lower spray arm spins freely
  • Detergent dispenser unobstructed
  • Test cycle run

Related Repair Guides