Parts for RAX4232KQ0 — Roper Washer

We found 40 parts confirmed to fit the Roper Washer RAX4232KQ0.

Compatibility table

Prices shown are an informational reference range only, not an offer or an Amazon price — RepairKitHub does not sell parts directly. Each part links to an Amazon search so you can compare current listings yourself.

Common failure areas on this model

The confirmed parts above group into a handful of failure areas. Here is what each points to and how to check it before you order anything.

Door and drum seals

Symptom: A door boot or gasket that's torn or losing its seal, letting water leak out during the wash or spin cycle.

Check: Check the door boot or gasket for tears, especially near the drain hole at the bottom, and confirm it isn't pinched or twisted where it clamps to the drum.

Parts in this group on RAX4232KQ0: WP3359586 (Washer Gasket Tub Ring).

General hardware and mounting parts

Symptom: A small mechanical or mounting part has failed, cracked, or gone missing.

Check: Compare the physical shape and mounting points to the original piece, and confirm the exact part number against your model plate before ordering.

Parts in this group on RAX4232KQ0: WP3347034 (Washer Vacuum Break), WP3956205 (Balance Ring Assembly), 285868 (Inner Tub Filter Plug Kit), W10820044 (Washer Cordpower), 285352 (Oil Seal Kit for Gearcase Input Shaft), 388253A (NEUTRAL DRAIN KIT), 285244 (Rear Leveling Foot), WP91939 (Washer Shaft Seal), WP3949550 (Washer Washer), 3951311 (Clutch), 62570 (Gear), 63320 (Pinion), 389140 (Washer Drive Block), 350930 (Spray Paint - 12 oz. - White), 72017 (Touch-Up Paint - White).

Controls, timers and wiring

Symptom: A cycle that doesn't advance, the wrong water level filling, an unresponsive display, or the washer not starting at all.

Check: Look for burn marks or a burnt smell near the board or terminals, and check whether buttons and knobs respond -- a unit that powers on but won't cycle often traces back to this group.

Parts in this group on RAX4232KQ0: W10339228 (Water Level Pressure Switch), W10335056 (Water Level Pressure Switch), W10807860 (Timer Knob), WP8572717 (Washer Capacitor Motor Start).

Suspension and tub hardware

Symptom: Excessive vibration, banging, or the machine "walking" during the spin cycle.

Check: Check that all leveling legs are actually contacting the floor, then inspect the suspension rods or springs for wear or a broken mount point.

Parts in this group on RAX4232KQ0: WPW10131112 (Agitator), WP63907 (Suspension Spring), 285219 (Suspension Pads - Package of 3), 388951 (Basketdriv).

Water inlet and drainage

Symptom: A washer that won't fill, fills slowly, won't drain, or leaves standing water in the tub.

Check: For fill problems, check the inlet valve's screen filters for sediment. For drain problems, check the pump for a jammed object and confirm the drain hose isn't kinked or looped too high.

Parts in this group on RAX4232KQ0: 285664 (Drain Hose with Clamp), 285871 (Tub-to-Pump Hose Kit), 3952164 (Washer Inlet Valve).

Storage, trim and cosmetic hardware

Symptom: A cracked shelf, broken door bin, worn hinge, or missing trim piece -- cosmetic and storage wear rather than a functional breakdown.

Check: Match the physical dimensions and mounting tabs of the old part before ordering; these pieces are often model-specific even between visually similar models.

Parts in this group on RAX4232KQ0: WP8546462 (Spin Tube Bearing), WP3946532 (Shield, Motor), W10846509 (Washer Screw, #10-32 x 5/8-in), 353424 (Washer Terminal Connector), WP64067 (Spring Outer Bracket), WP388326 (Console Screw), WP21366 (Washer Spanner Nut), 3349296 (Rack), 21366 (Washer Spanner Nut).

Drive system (belts, pulleys, motors)

Symptom: A drum or tub that won't turn, a burning-rubber smell, or a loud thump or squeal during a cycle.

Check: With power off, turn the drum or tub by hand -- resistance or grinding points to the motor or a bearing, and a cracked, glazed, or snapped belt is visible once the cabinet is open.

Parts in this group on RAX4232KQ0: WP3349985 (Washer Gear Case Cover Seal), 285753A (Direct Drive Motor Coupling), 3360630 (Gear Case), 62621 (Actuator).

Before you buy

Match RAX4232KQ0 exactly against the model and serial plate on the appliance itself before ordering anything — a single mismatched character can point to a different production run with different parts. Then check the part number printed or stamped on the part you are replacing against the part numbers in the table above; the printed number is the most reliable way to confirm fitment when a model has gone through multiple production runs. RepairKitHub does not sell parts directly — every part link above routes to an Amazon search for that part number so you can compare current listings and sellers yourself.

How to confirm this is your model

On most washers, the model and serial plate sits under the lid or on the back panel. Match every character exactly, including letters and dashes at the end — appliance model numbers often have similar prefixes but different suffixes for different production runs.

Neighbouring Roper Washer models

These model numbers sort next to this one in the catalog and are usually the same product family.

• RAX4232KQ1 — 37 parts
• RAX4232PQ0 — 31 parts
• RAX4232PQ1 — 31 parts
• RAX4232RQ4 — 43 parts
• RAX4233PQ0 — 32 parts
• RAX4232JQ0 — 36 parts
• RAS8333PQ1 — 45 parts
• RAS8333PQ0 — 37 parts
• RAS8245EW1 — 37 parts
• RAS8245EW0 — 37 parts

Other models with this exact parts list

Each model below is confirmed to share the identical compatible-parts list with this one.

• BYCW4271W0 — 18 parts
• CAWB427JQ0 — 36 parts

Still not sure?

Use the model lookup tool to search by model or part number, or start from the symptom your appliance is showing.