Parts for LT4900XMW2 — Whirlpool

We found 33 parts confirmed to fit the Whirlpool LT4900XMW2.

Compatibility table

Prices shown are an informational reference range only, not an offer or an Amazon price — RepairKitHub does not sell parts directly. Each part links to an Amazon search so you can compare current listings yourself.

Common failure areas on this model

The confirmed parts above group into a handful of failure areas. Here is what each points to and how to check it before you order anything.

General hardware and mounting parts

Symptom: A small mechanical or mounting part has failed, cracked, or gone missing.

Check: Compare the physical shape and mounting points to the original piece, and confirm the exact part number against your model plate before ordering.

Parts in this group on LT4900XMW2: 694321 (Slide Bar Guide), 350384 (Washer Plunger Kit), 80011 (Lid Bumper - Kit of 2), WP692400 (Washer Push-In Nut), 693152 (Console Bumper), 695075 (Motor), W11613302 (SEAL-DOOR), 690997 (Dryer Tri-Ring Retainer), WP660658 (Dryer Clampmotor), 358992 (Valve), 337351 (Switch), 690081 (Catch), 696144 (Strike), 350930 (Spray Paint - 12 oz. - White), 72017 (Touch-Up Paint - White).

Door, lid switches and latches

Symptom: The appliance won't start, or stops, unless the lid or door is fully latched shut.

Check: Listen for an audible click when the lid or door closes. No click, or a visibly cracked plastic tab on the latch, points to this part.

Parts in this group on LT4900XMW2: WP359807 (Washer Lid Switch Actuator), WPW10119828 (Lid Hinge Mounting Screw).

Heat control (thermostats, fuses, heating element)

Symptom: The appliance runs but heats or cools inconsistently, or shuts off partway through a cycle.

Check: With the appliance unplugged, check continuity across the part with a multimeter -- no continuity means it has failed.

Parts in this group on LT4900XMW2: 279506 (Heating Element Kit), 279457 (Heating Element Connection Wire Kit).

Storage, trim and cosmetic hardware

Symptom: A cracked shelf, broken door bin, worn hinge, or missing trim piece -- cosmetic and storage wear rather than a functional breakdown.

Check: Match the physical dimensions and mounting tabs of the old part before ordering; these pieces are often model-specific even between visually similar models.

Parts in this group on LT4900XMW2: WP692985 (Clip), W10828351 (Dryer Lint Filter and Cover), WP686711 (Dryer Door Handle), WP348023 (Dryer Door Hinge), 279771 (CLIP), 279220 (Felt Clip Kit), 349241 (Support).

Door and drum seals

Symptom: A door or drum seal that has lost its grip, letting water or conditioned air escape past it.

Check: Inspect the seal for tears, flattening, or gaps, and check it against your model's part number before ordering.

Parts in this group on LT4900XMW2: 279735 (Rear Felt Drum Seal with Adhesive), 96690 (Gasket).

Drive system (belts, pulleys, motors)

Symptom: A drum or tub that won't turn, a burning-rubber smell, or a loud thump or squeal during a cycle.

Check: With power off, turn the drum or tub by hand -- resistance or grinding points to the motor or a bearing, and a cracked, glazed, or snapped belt is visible once the cabinet is open.

Parts in this group on LT4900XMW2: 3394652 (Multi Rib Belt), W10837625 (Motor Pulley), 691366 (Dryer Idler Pulley).

Water inlet and drainage

Symptom: The unit isn't getting water when it should, or isn't draining or pumping it out when it should.

Check: Check the valve or pump for a clog or jammed object, and confirm the hose isn't kinked, restricted, or routed higher than the unit allows.

Parts in this group on LT4900XMW2: 285666 (Drain Hose).

Controls, timers and wiring

Symptom: A cycle that doesn't advance, an unresponsive display, or the unit not starting at all.

Check: Look for burn marks or a burnt smell near the board or terminals, and check whether buttons and knobs respond -- a unit that powers on but won't cycle often traces back to this group.

Parts in this group on LT4900XMW2: WP8572717 (Washer Capacitor Motor Start).

Before you buy

Match LT4900XMW2 exactly against the model and serial plate on the appliance itself before ordering anything — a single mismatched character can point to a different production run with different parts. Then check the part number printed or stamped on the part you are replacing against the part numbers in the table above; the printed number is the most reliable way to confirm fitment when a model has gone through multiple production runs. RepairKitHub does not sell parts directly — every part link above routes to an Amazon search for that part number so you can compare current listings and sellers yourself.

How to confirm this is your model

Check inside a door opening, on a back or side panel, or behind a removable panel or drawer for a label printed with the model and serial number. Match every character exactly, including letters and dashes at the end — appliance model numbers often have similar prefixes but different suffixes for different production runs.

Other models with this exact parts list

Each model below is confirmed to share the identical compatible-parts list with this one.

• LT5000XMW1 — 25 parts

Still not sure?

Use the model lookup tool to search by model or part number, or start from the symptom your appliance is showing.