Parts for 1106008700 — Kenmore Dryer

We found 12 parts confirmed to fit the Kenmore Dryer 1106008700.

Compatibility table

All 12 confirmed parts, ordered so parts that fit fewer models (more specific to this appliance) appear first.
Part #PartAlso fitsReference price
233155Thermostat3 models$36.13 · Amazon
239672Hinge Kit36 models$5.21 · Amazon
233550Foot42 models$4.49 · Amazon
234800Door Seal82 models$10.10 · Amazon
1751210-watt Bulb103 models$15.84 · Amazon
230148Terminal Block171 models$33.95 · Amazon
18849Washer Lid Hinge Bumper194 models$18.07 · Amazon
230132Spring285 models$7.47 · Amazon
90464Screw420 models$2.16 · Amazon
232402Clamp554 models$4.42 · Amazon
WP337186Dryer Single Door Spring986 models$7.47 · Amazon
W11613302SEAL-DOOR1,027 models$38.96 · Amazon

Prices shown are an informational reference range only, not an offer or an Amazon price — RepairKitHub does not sell parts directly. Each part links to an Amazon search so you can compare current listings yourself.

Common failure areas on this model

The confirmed parts above group into a handful of failure areas. Here is what each points to and how to check it before you order anything.

Heat control (thermostats, fuses, heating element)

Symptom: The dryer runs but produces no heat, or it shuts off partway through the cycle.

Check: With the dryer unplugged, check continuity across the part with a multimeter -- no continuity means it has failed. Clear the lint vent first, since a blocked vent is what usually trips a thermal fuse in the first place.

Parts in this group on 1106008700: 233155 (Thermostat).

Storage, trim and cosmetic hardware

Symptom: A cracked shelf, broken door bin, worn hinge, or missing trim piece -- cosmetic and storage wear rather than a functional breakdown.

Check: Match the physical dimensions and mounting tabs of the old part before ordering; these pieces are often model-specific even between visually similar models.

Parts in this group on 1106008700: 239672 (Hinge Kit), 230132 (Spring), 90464 (Screw), WP337186 (Dryer Single Door Spring).

General hardware and mounting parts

Symptom: A small mechanical or mounting part has failed, cracked, or gone missing.

Check: Compare the physical shape and mounting points to the original piece, and confirm the exact part number against your model plate before ordering.

Parts in this group on 1106008700: 233550 (Foot), 232402 (Clamp), W11613302 (SEAL-DOOR).

Door and drum seals

Symptom: A drum seal that's worn through, letting the dryer pull in room air instead of pushing heated air through the load.

Check: Look for the drum seal fraying or missing where it meets the front or rear bulkhead -- worn felt or foam here is visible once the front panel is off.

Parts in this group on 1106008700: 234800 (Door Seal).

Interior lighting

Symptom: The interior light doesn't turn on when the door opens.

Check: Confirm power is reaching the socket, then check the door-activated light switch before assuming the bulb itself is at fault.

Parts in this group on 1106008700: 17512 (10-watt Bulb).

Controls, timers and wiring

Symptom: A cycle that doesn't advance, an unresponsive display, or the dryer not starting at all.

Check: Look for burn marks or a burnt smell near the board or terminals, and check whether buttons and knobs respond -- a unit that powers on but won't cycle often traces back to this group.

Parts in this group on 1106008700: 230148 (Terminal Block).

Door, lid switches and latches

Symptom: The dryer won't run, or stops, unless the door is fully latched shut.

Check: Listen for an audible click when the door closes. No click, or a visibly cracked plastic tab on the latch, points to this part.

Parts in this group on 1106008700: 18849 (Washer Lid Hinge Bumper).

Before you buy

Match 1106008700 exactly against the model and serial plate on the appliance itself before ordering anything — a single mismatched character can point to a different production run with different parts. Then check the part number printed or stamped on the part you are replacing against the part numbers in the table above; the printed number is the most reliable way to confirm fitment when a model has gone through multiple production runs. RepairKitHub does not sell parts directly — every part link above routes to an Amazon search for that part number so you can compare current listings and sellers yourself.

How to confirm this is your model

On most dryers, the model and serial plate sits inside the door opening or behind the lint trap. Match every character exactly, including letters and dashes at the end — appliance model numbers often have similar prefixes but different suffixes for different production runs.

Neighbouring Kenmore Dryer models

These model numbers sort next to this one in the catalog and are usually the same product family.

Still not sure?

Use the model lookup tool to search by model or part number, or start from the symptom your appliance is showing.